Invisible fiber optic cable can be connected to a network port panel

Use fiber-to-Ethernet media converters at each end to connect an invisible fiber optic cable to your network port panel for a seamless, high-speed connection.Required Equipment

• Invisible fiber optic cable (e.g., InvisiLight single-mode fiber)
• Media converters (Ethernet-to-fiber and fiber-to-Ethernet)
• Ethernet cables to connect media converters to your network devices
• Adhesive or mounting tools for routing the fiber along walls or baseboards
• Cleaning wipes for fiber connectors to ensure optimal signal quality

Step-by-Step Installation

1. Plan the Route: Determine the path from your network port panel to the target device. Invisible fiber can be routed along baseboards, trim, or corners without being noticeable .
2. Run the Fiber Cable: Carefully lay the fiber along the planned path. Use the adhesive or mounting tools provided to secure it. Avoid sharp bends; most ultra-thin fibers tolerate bends down to 2.5mm radius .
3. Install Media Converters:
   • At the network port panel, connect the fiber end to the fiber input port of the media converter.
   • Connect an Ethernet cable from the media converter's Ethernet port to the network panel port.
   • At the device end, connect the fiber to the second media converter and then use an Ethernet cable to connect to the device (computer, router, or switch), .
4. Power On Devices: Plug in the media converters and ensure they are powered. Wait for the status lights to stabilize, indicating a successful fiber link .
5. Test the Connection: Verify connectivity by checking the network device or running a speed test. Disable Wi-Fi if necessary to force the device to use the wired connection .

Additional Tips

• Do not attempt to splice broken fiber; replace it if damaged .
• Future adjustments require a new fiber path; once adhered, the fiber cannot be moved .
• Compatibility: Ensure your network devices support Ethernet connections; the media converters handle the fiber-to-Ethernet conversion, so no special router is required . By following these steps, you can integrate an invisible fiber optic cable into your network panel, achieving a clean, high-speed, and visually unobtrusive connection.