Grounding wire of distribution box PE

26 mm 2 (10 AWG) ground wire must be used, and in all other markets a 6 mm 2 must be used. The correct connection method of Distribution box grounding wire mainly includes the following steps: 1. Power from factory ground must be installed by a qualified electrician. Grounding of the units: Attach a ground wire from one of. Each assembly e. the main grounding conductor from customer's power distribution panel as well as the other conductors of the grounding system outside of. Here are the steps on how to ground a power distribution box: 1. Preparation: First, you need to prepare some necessary tools, including grounding wire, grounding rod, voltmeter, insulating gloves and insulating tools. Make sure all tools are intact to prevent accidents during the grounding. Improper grounding or earthing of “Distributed Control Systems (DCS)” or “Power Electronic Systems (PES)” can result in either mal-operation of the system / controller or failure of electronic control cards or sometimes even the embedded control software getting erased.