Fiber optic cable laying end

The end of the cable will be against the ground, use a plastic sheet to keep the cable clean. Each “8” should be slightly offset from the previous one to minimize mechanical pressure. We terminate fiber optic cable two ways - with connectors that can mate two fibers to create a temporary joint and/or connect the fiber to a piece of network gear or with splices which create a permanent joint between the two fibers. These terminations must be of the right style, installed in a. Minimize mechanical pressure on the outer sheath at crossing points: (armoured) cables crossing each other generate points of high pressure, so it is important when laying in figure 8 loops it is done in a correct way. When laying loops of fiber on a surface during a pull, use “figure-8” loops to. Fiber optic cables have Kevlar aramid yarn or a fiberglass rod as their strength member. The information contained in this manual should serve as a guide to proper. This fiber optic installation method statement covers the termination of fiber optic cables with patch panel, network distribution cabinet NDC and door junction box but can be applicable for any kind of network installations.